Reading the gates
Start with the shuttle’s long edge. Follow it down the rail, past each turn and mirror, to see how it will meet the next gate.
Read the mark on the rim

The red edges show where the shuttle caught. Drag the shuttle until its long edge follows the slot, then tap − or + to fine-tune. The dashed outline marks your last launch. When a later job adds a second gate, check that the same launch angle clears both.
Play the coast campaignCarry the angle through a mirror

A mirror checks the incoming piece first, then reverses its tilt. A piece arriving at −20° leaves at +20°. A clockwise quarter turn adds 90°. That same −20° tilt would become +70°. Work through the gates from left to right.
Try the mirror dial in Silver lineWatch the gap on a geared sight

In North sight, turn the dial one degree clockwise. The first slot moves one degree the other way, changing their relative angle by two degrees. The second slot stays still. Once you launch, both slots lock in place. If you miss the geared gate, move the dial one degree and compare the two positions.
Try the reverse gear in North sightLead a moving opening

In The Night Watch a spinning wheel keeps turning while the shuttle travels. Look a little ahead of the opening. A swinging bell slows at the end of its arc, then speeds up through the centre. After a collision, the dashed frame marks the slot at contact.
Take the first watchChoose a daily launch
Every player gets the same three gates for the UTC date. The first gate turns the piece, so carry that new angle into both remaining openings. On the ranked board every launch counts. With equal attempts, compare the tightest gap on each run, rounded to a tenth. If those match too, the earlier clear ranks higher. Open a past date to practice that route.
Play today’s rotation puzzle