Coast workshop · Geared sights

Chart Room

Take a place at the chart table. In North sight, one dial turns the first sight against the shuttle.

At the launch bench

Aim
Press ← or → to turn 1° at a time, or hold Shift to turn 5° at a time. Hold either arrow to keep turning. You can also tap − or + for 1°, or drag sideways. While dragging, slide up a little for finer control.
Launch
Choose one starting angle for the whole rail, then press Enter or Space to launch.
After a miss
Look for the dashed outline left on the gate. Where a corner crosses the red rim, ease the dial a degree and try again.

Chart Room

North sight

2 gates

Turn the launch dial and watch Gate 1 wind the other way. Gate 2 stays fixed.

20°
← → 1° · Shift + ← → 5° · Enter or Space to launch

Drag to aim. Tap − or + to turn 1°.

Sign in to save scores and earn medals → · Global leaderboard

Why does the gap change so quickly?

Turn the shuttle one degree clockwise in North sight. The first slot turns one degree back, changing their relative angle by two degrees. Check the fixed second sight before you launch.

See the geared sight diagram

The coastal workshops

Each repair opens the next job. You can also start in the Mirror Gallery or the Chart Room.

Calibration

The coast lamp has gone dark. Fit the first shuttle to release its shutter.

5 jobs
  1. First fit
  2. The incline
  3. Cross-check
  4. Broadside
  5. The sleeve
Calibration medal

The Junction

Two supply rails meet beneath the lens. Guide the carrier past their shifted slots.

5 jobs
  1. Opposed
  2. Off center
  3. Head first
  4. Switchyard
  5. Three-stage relay
The Junction medal

Index Chamber

The lens carriage has lost its bearings. Set its index rings back in step.

5 jobs
  1. Quarter turn
  2. Counter-turn
  3. Back to zero
  4. Half-turn
  5. Counter-route
Index Chamber medal

Brake Assembly

The lens brake is still holding. Fit its cable and release pin to send a test beam to the mirror bench.

5 jobs
  1. Fine tolerance
  2. Return path
  3. The needle
  4. Split verdict
  5. First Beam Test
Brake Assembly medal

Mirror Gallery

The silver mirrors carry the beam out to sea. Set their angles for first light.

5 jobs
  1. Silver line
  2. Parallax
  3. Split light
  4. Afterimage
  5. Silver escapement
Mirror Gallery medal

Tide Chamber

The tide wheel drives the lamp. Feed its paddles through the high and low sluices.

5 jobs
  1. Low water
  2. Flood mark
  3. Paddle step
  4. Twin locks
  5. Ebb return
Tide Chamber medal

Chart Room

Set the sextant against the stars and chart the bearing out of the harbour.

5 jobs
  1. North sight
  2. Cross the meridian
  3. Paired stars
  4. Back sight
  5. True bearing
Chart Room medal

Lantern Room

Seat the lens, release its shutters and send the first beam over the water.

5 jobs
  1. Wick seat
  2. Prism seat
  3. The iris
  4. Twin shutters
  5. Coast signal
Lantern Room medal