Coast campaign · 40 puzzles

Set the dial.
Light the coast.

The coast lamp has gone dark. Turn the brass shuttle until it fits the slot, then launch.

At the launch bench

Aim
Press ← or → to turn 1° at a time, or hold Shift to turn 5° at a time. Hold either arrow to keep turning. You can also tap − or + for 1°, or drag sideways. While dragging, slide up a little for finer control.
Launch
Choose one starting angle for the whole rail, then press Enter or Space to launch.
After a miss
Look for the dashed outline left on the gate. Where a corner crosses the red rim, ease the dial a degree and try again.

CALIBRATION / 01

First fit

1 gate

Line up the shuttle’s long edge with the slot, then launch.

−34°
← → 1° · Shift + ← → 5° · Enter or Space to launch

Drag to aim. Tap − or + to turn 1°.

Sign in to save scores and earn medals → · Global leaderboard

The coastal workshops

Each repair opens the next job. You can also start in the Mirror Gallery or the Chart Room.

Calibration

The coast lamp has gone dark. Fit the first shuttle to release its shutter.

5 jobs
  1. First fit
  2. The incline
  3. Cross-check
  4. Broadside
  5. The sleeve
Calibration medal

The Junction

Two supply rails meet beneath the lens. Guide the carrier past their shifted slots.

5 jobs
  1. Opposed
  2. Off center
  3. Head first
  4. Switchyard
  5. Three-stage relay
The Junction medal

Index Chamber

The lens carriage has lost its bearings. Set its index rings back in step.

5 jobs
  1. Quarter turn
  2. Counter-turn
  3. Back to zero
  4. Half-turn
  5. Counter-route
Index Chamber medal

Brake Assembly

The lens brake is still holding. Fit its cable and release pin to send a test beam to the mirror bench.

5 jobs
  1. Fine tolerance
  2. Return path
  3. The needle
  4. Split verdict
  5. First Beam Test
Brake Assembly medal

Mirror Gallery

The silver mirrors carry the beam out to sea. Set their angles for first light.

5 jobs
  1. Silver line
  2. Parallax
  3. Split light
  4. Afterimage
  5. Silver escapement
Mirror Gallery medal

Tide Chamber

The tide wheel drives the lamp. Feed its paddles through the high and low sluices.

5 jobs
  1. Low water
  2. Flood mark
  3. Paddle step
  4. Twin locks
  5. Ebb return
Tide Chamber medal

Chart Room

Set the sextant against the stars and chart the bearing out of the harbour.

5 jobs
  1. North sight
  2. Cross the meridian
  3. Paired stars
  4. Back sight
  5. True bearing
Chart Room medal

Lantern Room

Seat the lens, release its shutters and send the first beam over the water.

5 jobs
  1. Wick seat
  2. Prism seat
  3. The iris
  4. Twin shutters
  5. Coast signal
Lantern Room medal

    From the keeper’s workbench

    A dashed outline of the tilted shuttle crosses the red top and bottom edges of the slot.

    Marks on the first gate

    At −34°, both ends catch. The dashed outline shows how much of the shuttle sits above and below the slot.

    Read the collision guide
    The Silver line rail has a mirror at the first gate and an oppositely tilted slot at the second.

    On the far side of a mirror

    Silver line sends a nose-up shuttle out nose-down. Read the second slot with that reflected tilt in mind.

    Play Silver line
    North sight has a reverse-gear marking below the first slot and a fixed sight on the right.

    Two sights, one dial

    In North sight, turning the dial clockwise sends the first slot counterclockwise. The second slot holds its bearing. Can you find one angle that fits both?

    Play North sight
    Watch the three mechanisms in motion
    Play First fit