Coast workshop · Reflection

Mirror Gallery

Sight along the brass shuttle. On the Silver line rail a nose-up shuttle comes out of the mirror nose-down.

At the launch bench

Aim
Press ← or → to turn 1° at a time, or hold Shift to turn 5° at a time. Hold either arrow to keep turning. You can also tap − or + for 1°, or drag sideways. While dragging, slide up a little for finer control.
Launch
Choose one starting angle for the whole rail, then press Enter or Space to launch.
After a miss
Look for the dashed outline left on the gate. Where a corner crosses the red rim, ease the dial a degree and try again.

Mirror Gallery

Silver line

2 gates

Enter the silver gate nose-up. Its mirror sends you out nose-down.

Try the mirror dial

Turn the launch dial below. A mirror reverses its tilt after the piece clears the slot.

In Out
18°
← → 1° · Shift + ← → 5° · Enter or Space to launch

Drag to aim. Tap − or + to turn 1°.

Sign in to save scores and earn medals → · Global leaderboard

Which angle reaches the second gate?

Trace the long edge through the first slot. A tilt of −20° becomes +20° on the other side of the mirror. Open the mirror dial beside the board to compare both readings as you aim.

See the mirror diagram

The coastal workshops

Each repair opens the next job. You can also start in the Mirror Gallery or the Chart Room.

Calibration

The coast lamp has gone dark. Fit the first shuttle to release its shutter.

5 jobs
  1. First fit
  2. The incline
  3. Cross-check
  4. Broadside
  5. The sleeve
Calibration medal

The Junction

Two supply rails meet beneath the lens. Guide the carrier past their shifted slots.

5 jobs
  1. Opposed
  2. Off center
  3. Head first
  4. Switchyard
  5. Three-stage relay
The Junction medal

Index Chamber

The lens carriage has lost its bearings. Set its index rings back in step.

5 jobs
  1. Quarter turn
  2. Counter-turn
  3. Back to zero
  4. Half-turn
  5. Counter-route
Index Chamber medal

Brake Assembly

The lens brake is still holding. Fit its cable and release pin to send a test beam to the mirror bench.

5 jobs
  1. Fine tolerance
  2. Return path
  3. The needle
  4. Split verdict
  5. First Beam Test
Brake Assembly medal

Mirror Gallery

The silver mirrors carry the beam out to sea. Set their angles for first light.

5 jobs
  1. Silver line
  2. Parallax
  3. Split light
  4. Afterimage
  5. Silver escapement
Mirror Gallery medal

Tide Chamber

The tide wheel drives the lamp. Feed its paddles through the high and low sluices.

5 jobs
  1. Low water
  2. Flood mark
  3. Paddle step
  4. Twin locks
  5. Ebb return
Tide Chamber medal

Chart Room

Set the sextant against the stars and chart the bearing out of the harbour.

5 jobs
  1. North sight
  2. Cross the meridian
  3. Paired stars
  4. Back sight
  5. True bearing
Chart Room medal

Lantern Room

Seat the lens, release its shutters and send the first beam over the water.

5 jobs
  1. Wick seat
  2. Prism seat
  3. The iris
  4. Twin shutters
  5. Coast signal
Lantern Room medal